BD Alaris - General Setup and Operation; Attaching the System to an IV Pole; Attaching and Detaching a Module; Attaching a Module

Chapter 2—BD Alaris™ PCU Model 8015 and Alaris™ PCU Model 8015
18 BD Alaris
TM
System with Guardrails
TM
Suite MX User Manual
General Setup and Operation
Attaching the System to an IV Pole
Attaching and Detaching a Module
Modules can be attached to either side of the PCU or to either side of another module. The process to
attach or detach is the same for either side, whether attaching/detaching to/from a PCU or another module.
An individual hospital/facility can choose
to permanently attach modules. To remove permanently attached
modules, contact qualified service personnel.
Attaching a Module
The system is designed to operate a maximum of four infusion or monitoring modules. Modules added in
excess of four are not recognized by the system. The auto-ID module can be included as a fifth module. A
module can be attached in any position; however, when mounted on an IV pole, it is recommended that a
balanced configuration be maintained.
Application of adhesive tape or other materials
to the sides of the PCU and modules can prevent proper
latching.
CAUTION
CAUTION
When attaching the BD Alaris and Alaris systems to an IV pole, ensure the pole clamp is
tightened securely to prevent the system from slipping.
WARNING
Inserting a finger or other object into the inter-unit interface (IUI) connector when the module is
attached to the PCU could result in electrical shock.