Programming
BD Alaris
TM
System with Guardrails
TM
Suite MX User Manual 87
Programming
Introduction
The system can be programmed with Guardrails suite MX protection or with no Guardrails suite MX
protection:
• Guardrails suite MX protection
• Manual Programming (see Manually Programming — Primary Infusion on
page 88)
• Programming with Interoperability (see Programming with Interoperability and Guardrai
ls™
Suite MX on page 121)
• A
uto-ID (Refer to Alaris™ Auto-ID Module Model 8600 on
page 309)
• No Guardrails suite MX protection
• Manu
al Programming — No Guardrails™ Selections on page 14
2
• No Guardrails - Basic Infusion with Drug Calculation on pa
ge 144
References throughout this procedure to specific drugs and drug doses are for illustration purpos
es only.
Refer to specific drug product labeling for information concerning appropriate administration techniques
and dosages.
See Features and Definitions on pa
ge 176 and BD Alaris™ PCU Model 8015 and Alaris™ PCU Model
8015 on page 15 for info
rmation about:
•Displays
• Operating Features, Controls, Indicators
The majority of user interface programming is identical for both the pu
mp module and syringe module.
When referring to both modules, the term “infusion modules” is used. The modules are referred to
singularly as the pump module and the syringe module.
To Next Page
Loading...
