BD Alaris - Regulations and Standards; Compliance; Electromagnetic Environment

Appendix A—Troubleshooting and Maintenance
354 BD Alaris
TM
System with Guardrails
TM
Suite MX User Manual
Regulations and Standards
Compliance
Electromagnetic Environment
BD Alaris
TM
System
The digital apparatus does not exceed the Class B limits for radio noise emissions from digital apparatus
set out in the radio interference regulations of the Canadian Department of Communications (DOC).
Le present appareil numerique n'emet pas de bruits radiolelectriques depassant le
s limites applicables aux
appareils numeriques de la Classe B prescrites dans le reglement sur le brouillage radioelectrique edicte
par le Ministere des Communications du Canada.
This system has been tested and fou
nd to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the system is operated in a commercial environment.
This system generates, uses, and can radiate radio frequency energy
. If it is not installed and used in
accordance with the applicable user manual, it might cause harmful interference to radio communications.
The authority to operate this system is conditioned by the requirement that no modifications are made to
th
e sy
stem unless the changes or modifications are expressly approved.
This Class B digital apparatus meets all requirements of the Canadian
Interference-Causing Equipment
Regulation.
Cet appareil numerique de la Clas
se B respecte
toutes les exigences du Reglement sur le materiel
brouilleur du Canada.
The system includes an IEEE 802.11
RF transmitter, as designated by the icon on the rear of the system. It
operates on the following frequencies with a maximum radiated power of 100 mW:
• 80
2.11a: 5 GHz b
and, up to 54 Mbps physical RF specification.
• 802.11b: 2.4 GHz band, up to 1
1 Mbps physical RF specification.
• 802.11g: 2.4 G
Hz band, up to 54 Mbps physical RF specification.
• 802.11n: 5 GHz or 2.4 GHz band, u
p to 72 Mbps physical RF specification.
The registration numbers are identified on the RF card installed in the rear of the PCU.
Ta
bles: The system is intended for use in the electromagnetic environments specified in the following
tabl
es.
CAUTION
CAUTION
Any changes or modifications not expressly approved by the personnel responsible for
compliance could void the user's authority to operate the system.