Regulations and Standards
BD Alaris
TM
System with Guardrails
TM
Suite MX User Manual 359
Compact Flash Wireless Networking Module
The CF Wireless module contains a radio frequency, wireless, local-area network interface (RF card). The
RF card allows the system to communicate with the systems manager connected to the hospital
information system. The RF card is compliant with the rules and regulations in the locations where the CF
Wireless module is sold, and is labeled as required.
The United States Federal Communications Commission (FCC) and Industry Canada (IC) id
entification
numbers are visible through the CIB’s clear plastic cover. If an international country approval stamp is
required, it is placed adjacent to the identification numbers in the area provided. If the FCC identification
number or country approval stamp is not easily visible, the RF card cover may be removed so that the
information provided can be read. If the RF card cover is removed, ensure that it is reattached—using the
screws that were removed, to ensure that the RF card is securely retained and protected against liquid
ingress and damage.
The Class B digital device limits a
re designed to provide reasonable protection against harmful
interference when the device is operated as intended. This device generates, uses, and can radiate radio
frequency energy. If it is not installed and used in accordance with the applicable user manual, it might
cause harmful interference to radio communications.
If the device does cause harmful interference to radio or television reception (determined by powering
system off
and on), one or more of the following corrective actions should be taken:
• Reorient or relocate receiving antenna.
• Increase separation distance between system and receiver.
• Connect system into an outlet on a circuit
different from that to whic
h receiver is connected.
This Class B digital device meets the requirements of the
Canadian Interference Causing Equipment
Regulations.
Cet appareil numérique de la Clas
se B respecte
toutes les exigences du Reglement sur le Matériel
Brouilleur du Canada.
This Class B digital device meets the requirements of the
International community.
Australian Communications Authority
Applicant:
Becton Dickinson Pty Ltd
4 Research Park Drive
North Ryde, NSW
Australia 2113
Phone: 02 9838 0255
Fax: 02 9674 4444
To Next Page
