If objects 0x6046/1 or 0x6046/2 were written and then a save parameters command
(object 0x1010
) processed, the object values are stored in non volatile memory. After
the next power on of the inverter, the previously set values are reactivated and ove
write the settings of parameters Minimum Frequency 418 and Maximum Freque
In Positioning applications the overall speed can fall below or exceed the limits defined
by Minimum and Maximum frequency due to the influence of the Position controller.
The output of the Position Controller can be limited by
1118.
CB: Control byte SI: Sub Index All values in hexadecimal without leading 0x
120 CM-CAN ACU 04/13
To Next Page
Loading...
Need help?
General
