Network Settings
130 ClareVision Plus Network Video Recorder User Manual
3. Enter Alarm Host IP and Alarm Host Port in the text fields.
The Alarm Host IP refers to the IP address of the remote PC on which the
Network Video Surveillance Software is installed. The alarm host port must
match the alarm monitoring port configured in the software.
4. Click Apply to save and exit the interface.
Configuring multicast
You can configure multicast for live view on more than 128 cameras through the
network for 64-Channel NVRs. You can connect over 64 cameras using the
multicast function for the 4-Channel NVR, 8-Channel NVR, and 32-Channel
NVR.
A multicast address spans the Class-D IP range from 224.0.0.0 to
239.255.255.255. We recommend that you use IP addresses ranging from
239.252.0.0 to 239.255.255.255.
To configure multicast:
1. Browse to the Network Settings interface.
Menu > Configuration > Network
2. Click the More Settings tab.
3. Set multicast IP, as shown below. When adding a device to the Network
Video Surveillance Software, the multicast address must match the NVR’s
multicast IP.
4. Click Apply to save and exit the interface.
Note: The multicast function is supported by the network switch to which the
NVR connects.
Configuring RTSP
The RTSP (Real Time Streaming Protocol) is a network control protocol used in
communication systems to control streaming media servers.
To configure RTSP:
1. Browse to the Network Settings menu.
Menu > Configuration > Network
2. Click the More Settings tab.
3. Enter the RTSP port number in the RTSP Port field.
The default RTSP port is 554. Change it according to your requirements.
4. Click Apply to save and exit the menu.
To Next Page
Loading...
