Comtech EF Data CDM-570 - Page 472

CDM-570/570L Satellite Modem with Optional IP Module Revision 12
Appendix K MN/CDM570L.IOM
K–10
(ODU SELECT) ODU CONFIG: ODU RX Æ Slope
ODU Rx Slope Mode:
Manual Calibrated (◄ ►)
Use the
◄ ► arrow keys select Manual or Calibrated, and then press ENTER.
(ODU SELECT) ODU CONFIG: ODU RX ÆSlope Æ Manual
ODU Rx Slope:
0.0 (▲ ▼,ENT)
Use the
▲ ▼ arrow keys to edit the ODU Rx Slope setting, and then press ENTER.
(ODU SELECT) ODU CONFIG: Misc
MISC: Cold-Start AFR LNA
XRef Ref-Adjust RTC (◄ ►)
Use the ◄ ► arrow keys to select Cold-Start, AFR, LNA, XRef, Ref-Adjust, or RTC, and
then press ENTER.
(ODU SELECT) ODU CONFIG: MISC Æ Cold-Start
Cold-Start State:
Enabled Disabled (◄ ►)
Use the ◄ ► arrow keys to select Enabled or Disabled, and then press ENTER.
(ODU SELECT) ODU CONFIG: MISC Æ AFR (Auto Fault Recovery)
Auto Fault Recovery:
Enabled Disabled (◄ ►)
Use the ◄ ► arrow keys to select Enabled or Disabled, and then press ENTER.
(ODU SELECT) ODU CONFIG: MISC Æ LNA
LNA: State Curr-Window
Cal Fault-Logic (◄ ►,ENT)
Use the ◄ ► arrow keys to select State, Curr-Window, Cal, or Fault-Logic, and then
press ENTER.
(ODU SELECT) ODU CONFIG: MISC Æ LNA Æ State
ODU LNA State:
On Off (◄ ►,ENT)
To control whether or not the CSAT provides LNA POWER via the Receive RF
Cable: Use the ◄ ► arrow keys to select On or Off, and then press ENTER.