Ericsson RX8000 - Using the Web Browser; Setting up Web Browser Remote Control

Using the Equipment
EN/LZT 790 0005 R7A
3-17
ALARMS
INPUT
OUTPUT
SERVICE
ENVIRONMENT
SERVICE
VIDEO NOT RUNNING
SET ALARM
DECODER X NOT RUNNING 1..2 or 1..6
SET ALARM
CLOSED CAPTION FAIL
SET ALARM
FILTER OUTPUT OVERFLOW
NO ALARM
OUTPUT
IPO ETHERNET IF 1 DOWN
NO ALARM
IPO ETHERNET IF 2 DOWN
NO ALARM
INPUT
NO TS LOCK
SET ALARM
ENV
OVERTEMPERATURE
SET ALARM
TEMP (MAX VALUE)
55
FAN X FAILED
SET ALARM
CA ERROR
SET ALARM
Figure 3.7 Sub-menu Alarms
Note: The detail of each front panel element is explained later on in this chapter.
3.4 Using the Web Browser
The Web Browser interface is available as a standard feature on all of the RX8000
IRDs. As of software version 8.0.0, the RX8000 can be configured to present one of
two web interface modes:
• Dashboard View – A simplified view showing the most common RX8000
options on a single page that is compatible with most modern web browsers.
This feature available when the RX8XXX/SWO/DASHBOARD license is
enabled.
• Advanced View – The classic web interface that has always been presented by
the RX8000 and exposes all of the RX8000 options across a number of tab
views. This mode is unchanged from the classic web interface and remains
compatible with the browsers listed in section 3.4.1.
The Dashboard View will be presented by default but both modes have a button in
the top right corner of the web interface to allow the user to switch between modes.
3.4.1 Setting Up Web Browser Remote Control
A personal computer (PC) running a Web Browser can be used to configure, control
and monitor the IRD remotely. The following web browsers have been tested:
• Microsoft Internet Explorer (This is the only browser supported by Ericsson)