Using the Equipment
The default settings from the factory are:
User Name: username
Password: password
When access has been granted for the first time, it is recommended that the XPO
password is changed immediately. This can be changed by navigating to the Device
Info > XPO Password Protection option from the Advanced View:
Figure 3.9 XPO Password Protection Settings
Enable/Disable Password Protection
• Enable Password Protection – This control overrides the password protection
control. When enabled, the user must enter their password credentials every
time a new web interface session is connected to the RX8000 device before
being able to modify its configuration. When disabled (the default), anyone can
gain access to the RX8000 web interface and modify its configuration.
Change Password
• User Name – Used to enter the new desired user name.
• Old Password – Used to enter the current password.
• New Password – Used to enter the new desired password.
• Confirm New Password – Used to confirm the new desired password.
To Next Page
Loading...
