Using the Equipment
• Uptime – The elapsed time since power-up.
• Input Status – The input TS lock status of the unit.
• Video Status – The decode status of the currently selected video decoder.
• Audio Status – The decode status of the currently selected audio decoders.
• CA Status – The status of the descrambler block within the RX8000.
• Service Filter Status (shown if licensed) – Indicates the state of the service
filter block.
• Output Feed – The status of the output Transport Stream feed.
• Mode – Indicates whether unit configuration is active or redundant.
A small window located at the bottom left of the Status Page will show events raised
and all the necessary details of those events.
The About button, located on the top right-hand side of the Status page shows,
when selected, details of the IRD such as software version and serial number.
3.9.2 Device Info
The Device Info page provides access to system level settings of the IRD. To view
this web page, select the Device Info tab from the top of the current web page.
Figure 3.17 Device Info Web Page
To Next Page
