Using the Equipment
Product Information
• Name – This field contains a name string that can be assigned by the user. The
last saved name is displayed on power-up but may be replaced by the user. The
default name is the IRD model name.
• Product Name – The model of the product (non-editable).
• Unit Chassis Ident – This is a unique identity value that matches the label
printed on the side of the device chassis.
• Build/Environment/Network Settings/Modules/Trap Destination Table –
These buttons access sub-menu pages, described below.
Date and Time
• Current Time – The time taken from the input Transport Stream.
• Uptime – The elapsed time since power-up.
Front Panel LockOut
• Front Panel Lockout On/Off – Indicates whether the front panel controls are
active or inactive.
Front Panel Control
• Disable Idle Menu Screen Saver – Disables the front panel screen saver. The
screen saver is activated if there is no navigation activity for more than 5
minutes.
Reboot Device
• Reboot Unit – Selecting this button will perform a hardware reset of the IRD.
Reset Parameters to their Factory Default values
• Reset Parameters to Factory Defaults – Selecting this button will set all
parameters to their factory default values (except for the network IP parameters
e.g. IP address and subnet mask) and perform a hardware reset of the IRD.
Flush Quality Logs storage
• Flush all Quality Logs – Selecting this button will flush all the quality logs.
A number of further web pages are accessible from the Device Info page and these
are described in the following paragraphs.
3.9.2.1 Device Info > Build
This page gives details of the build and version information for the equipment. There
are no fields on this page that may be edited by the user.
To view this page, select the Build button from the Device Info Page.
To Next Page
Loading...