EasyManua.ls Logo

Ericsson RX8000 - Over Air Control; Over Air Extended Carrier Timeout; Power up Carrier; Reset Pin

Ericsson RX8000
500 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Using the Equipment
3-158
EN/LZT 790 0005 R7A
DIRV5 |ENTER NEW PIN
5.2.5 |****
3.11.4.7.7 Reset Pin
This menu allows the user to enter the Lock-Out Reset PIN. This PIN resets the
Local Lock-Out PIN to its default value.
Please contact Ericsson Customer Support to determine the Reset PIN.
DIRV5 |RESET PIN
5.2.7 |*************
3.11.4.7.8 Over Air Extended Carrier Timeout
This menu allows the user to extend the timeout used to determine a loss of carrier.
When in extended mode the carrier timeout is changed from a value in seconds to a
value in minutes. If a loss of carrier is detected and the timeout occurs, the Director
functionality of the receiver may cause a retune to the Emergency Home Carrier if
it has been defined/configured.
DIRV5 |OVER AIR EXTD CARRIER TIMEOUT
5.2.8 |FALSE
3.11.4.7.9 Over Air Control
This menu allows the user to set the unit into Over Air Control mode. When the unit
is in Over Air Control mode it will action any Director Over Air Command sent from
the Director Head-End, otherwise they will be silently ignored.
DIRV5 |OVER AIR CONTROL
5.2.9 |FALSE
3.11.4.7.10 Power Up Carrier
This menu allows the user to view the tuning parameters and assigned Service ID
configured as the Power Up Carrier. On power up of the receiver, the Power-Up
Carrier settings will be applied if the Over Air Control mode was set to Enabled.
This will override any tuning parameters and service selection that the unit was
tuned to when it powered down or reset. This carrier can only be configured by
Director head-end using Director Over Air Commands. By default the carrier settings
are cleared and therefore not used.
DIRV5 |POWER-UP CARRIER
5.2.9 |TEST SERVICE 1

Table of Contents