Ericsson RX8000 - Alarm Identifier Lists; Alarm Modes; Compatibility Mode; Decode Alarm Identifiers

Alarm Identifiers
EN/LZT 790 0005 R7A
C-3
C.1 Introduction
This section lists the fixed Alarm Identifiers used when the Alarm Mode is configured
to Compatibility Mode.
C.1.1 Alarm Modes
C.1.1.1 Dynamic Mode
The dynamic mode alarm functionality utilizes the next available incrementing
identifier assigned at start-up. These identifiers will change depending on the cards
detected in the unit configuration.
C.1.1.2 Compatibility Mode
The compatibility mode setting uses pre-defined identifiers assigned at startup. This
in-turn allows the identifier of different units to be tracked through the external
control system consistently. These identifiers are listed in the following sections.
C.2 Alarm Identifier Lists
C.2.1 Generic Alarm Identifiers
Table C.1 Generic Alarm Identifiers
Name Identifier Description
No TS Lock 1000 No valid transport stream is available
on selected input
No Primary Input Lock 1001 Primary TS input failure
No Secondary Input Lock 1002 Secondary TS input failure
C.2.2 Decode Alarm Identifiers
Table C.2 Decode Alarm Identifiers
Name Identifier Description
Video Not Running 1010 Video decode is not in the running
state
Audio 1 Not Running 1011 Audio instance 1 is not in the running
state
Audio 2 Not Running 1012 Audio instance 2
Audio 3 Not Running 1013 Audio instance 3
Audio 4 Not Running 1014 Audio instance 4