Ericsson RX8000 - Device Info - Modules

Using the Equipment
3-38
EN/LZT 790 0005 R7A
• Incorrect MAC Address – This option is only exposed on some RX8300 variant
IRDs where there was an issue with the assignment of MAC address to the
Control Ethernet ports. Changing this setting will result in the Control MAC
address being changed, potentially causing a loss of connectivity to the
receiver.
- Clearing this tick box will mean the correct MAC address is calculated and
applied to the Control Ethernet ports.
- Setting this tick box will mean the legacy MAC address is calculated and
applied to the Control Ethernet ports.
3.9.2.4 Device Info > Modules
This page gives a list of all modules contained in the equipment chassis.
There are no fields on this page which may be edited by the user. Selecting the
Refresh button will update current settings and status values.
To view this page, select the Modules button from the Device Info Page.
Figure 3.21 Device Info > Modules Web Page
The following modules are supported by the unit:
Table 3.3 Supported Modules
Board Type Description
1900 RX8200 Motherboard
1901 RX8310/20 Motherboard
1902 RX8315/30 Motherboard
1910 Control Interface (RX8200/8252 only)
1911 DVB S2 Input
1912 DVB S2 2
nd
Generation Input (RX8310B only)
1913 8VSB Terrestrial Input
1914 IP Input
1915 HD Video Output (RX8200 only)
1916 Analogue Audio Output