Using the Equipment
• DISABLE – PAA mode will not be suppressed if a PAA service is selected. The
audio component selections for each audio decoder will be selected as per their
unique PAA language descriptor. Component selections cannot be overridden
by the user.
• ENABLED – PAA mode will be suppressed if a PAA service is selected. The
audio component selections for each audio decoder will be as per the PMT
order. Component selections assigned to each audio decoder can be overridden
by the user.
The section 3.15.5 Channel Configuration: Phase Aligned Audio (PAA) describes
the behavior in more detail.
3.14.5.2 SDI Embedding
This menu provides sub-menus for viewing and editing of SDI embedded audio
settings. To access this menu from the Audio menu, press the (Forward) key.
AUDIO |SDI EMBEDDING
4.8 | >
3.14.5.2.1 CH 1+2 Embedding
This menu enables viewing and editing of Channel 1 and 2 for audio embedding.
CH 1+2 |NO EMBEDDING
4.8.1 |---
After selecting the Edit key, use the (Up) (Down) keys to toggle between the
available audio decoders. The options presented will depend on what audio
decoders are available and the Channel Configuration mode selected.
3.14.5.2.2 CH 3+4, 5+6, 7+8, 9+10, 11+12, 13+14 and 15+16 Embedding
The embedding menus for the remaining channels are identical to those of CH 1+2,
described above.
CH x+x |NO EMBEDDING
4.8.x |---
To Next Page
Loading...