Using the Equipment
3.10.5.10 Multicast Input Setup
Figure 3.51 IP Input Stream Setup
3.10.5.10.1 Listening Stream Section
• FEC Enable – Enables the user to ENABLE/DISABLE Forward Error Correction.
This facility is only available when FEC is licensed.
• Mcast IP 1/1 Address – Primary Multicast/Unicast address of listening IP TS. In
case of Unicast this address should be equal to local IP address.
• Mcast IP 1/2 Address –Secondary Multicast/ address of listening IP TS. In case
of Unicast or no multicast redundancy this should be left as 000.000.000.000
• Unicast Enable – Placing a check in the box enables the Unicast mode for the
primary stream on Port 1/2.
• Source IP Address 1/1 – Enables the user to set the Primary multicast Source
IP Address for the primary stream on Port 1/2.
• Source IP Address 1/2 – Enables the user to set the Secondary multicast
Source IP Address for the primary stream on Port 1/2.
• UDP Port 1/1 – Listening UDP port for primary multicast.
• UDP Port 1/2 – Listening UDP port for secondary multicast.
• Column Port 1/1 – Colum port for primary multicast; by default it is “Listening
UDP port + 2”, but can be reconfigured.
• Column Port 1/2 – Colum port for secondary multicast; by default it is “Listening
UDP port + 2”, but can be reconfigured.
• Row Port 1/1 – Row port for primary multicast by default it is “Listening UDP
port + 4”, but can be reconfigured.
• Row Port 1/2 – Row port for secondary multicast by default it is “Listening UDP
port + 4”, but can be reconfigured.
• De-Jitter Buffer Level – IP de-jitter buffer level in milliseconds.
To Next Page
