Ericsson RX8000 - Auto Tuning; System B;G VHF Channel Mapping

Using the Equipment
3-112
EN/LZT 790 0005 R7A
Table 3.9 System B/G VHF Channel Mapping
Channel
Start Frequency
(MHz)
Center Frequency
(MHz)
End Frequency
(MHz)
VHF B05 174 177.5 181
VHF B06 181 184.5 188
VHF B07 188 191.5 195
VHF B08 195 198.5 202
VHF B09 202 205.5 209
VHF B10 209 212.5 216
VHF B11 216 219.5 223
VHF B12 223 226.5 230
The “channels found” menu item (on the Advanced menu page) is populated after a
frequency scan has found all of the channels the unit can tune to in its current
location. If the unit is tuned using either a frequency or a channel the item “channels
found” will show NO SELECTION.
Note: “Channels found” is of the highest priority when changing all 3 items (i.e.
XML download).
Auto Tuning
The unit can be “auto-tuned” to find a service this uses the following controls:
• Start Searching With Modulation – This indicates which modulation mode the
tuner will begin with when retune now is selected. This can be:
- DVB-T
- DVB-T2
- UNKNOWN (this will try both modulation modes)
Notes: A license key is required to enable DVB-T2 functionality.
• Start Searching with Bandwidth – This indicates which bandwidth type the
tuner will being with when retune now is selected. This can be:
- 6 MHz
- 7 MHz
- 8 MHz
- UNKNOWN (this will try both modulation modes)
• Retune Now – This starts the process of searching for a channel.
Note: Scanning status will display Normal retuning during tuning.