Using the Equipment
3.9.3.6 Service Alarms
Figure 3.28 Alarm Settings for Service Section
Service
• Video Not Running – Select the alarm condition from the drop-down menu to
be activated when video is not running (Set Alarm /No Alarm).
• Video Not Running (relay mapping) – Place a check mark in the box to
activate relay mapping for video not running.
• Audio Decoder 1/2/3/4/5/6 – Select the alarm condition from the drop-down
menu to be activated when Audio Decoder 1/2/3/4/5/6 is not running (Set Alarm
/No Alarm).
• Audio Decoder 1/2/3/4/5/6 (relay mapping) – Place a check mark in the box to
activate relay mapping for Audio Decoder 1/2/3/4/5/6 not running.
• Closed Caption Fail – Select the alarm condition from the drop-down menu to
be activated when closed caption fails (Set Alarm /No Alarm).
• Closed Caption Fail (relay mapping) – Place a check mark in the box to
activate relay mapping for closed caption fails.
• CA Error – Select the alarm condition from the drop-down menu to be activated
when a Conditional Access error is detected (Set Alarm /No Alarm).
• CA Error (relay mapping) – Place a check mark in the box to activate relay
mapping for Conditional Access error.
• SNTP Sync Error – Select the alarm condition from the drop-down menu to be
activated when an SNTP time server cannot be found (Set Alarm /No Alarm).
To Next Page
Loading...