Ericsson RX8000 - Decode - Asynchronous Data

Using the Equipment
3-332
EN/LZT 790 0005 R7A
3.17.7.6 Decode > Asynchronous Data
• LSD setting PID – Enables the selection of the PID from a drop-down menu.
• User PID – Specifies the User PID that can be selected from the LSD Setting
PID option.
• Stream type – Specifies the stream type of the incoming Low Speed Data to be
handled by the RX8000.
- TTV_F2 format
- DVB format
- Piped format
• Current Baud Rate – Displays the baud rate of the data stream being output
from the RS232 port.
• Enabled – Enables or disables the Low Speed Data output from the RS232
port.
• Status – Reports the status of the Low Speed Data being processed.
- Running – Low Speed Data is being filtered from the incoming stream and
being processed.
- Stopped – No Low Speed Data is being processed.
Note: Because the data is RS232, this does not reflect the status of the down-
stream connection
• Baud rate – Specifies the default Baud Rate at which the Low Speed Data
should be output from the RS232 port (1200, 2400, 4800, 9600, 19200 or 38400
bps).
3.17.7.7 Front Panel Setup
3.17.7.7.1 Status
This menu allows the user to select the state of the Low Speed Data output
STATUS |ENABLED: DISABLED
4.10.1 |RUNNING: STOPPED
Use the  (Up) and  (Down) keys to select either ENABLED or DISABLED for
the low speed data enabled state
3.17.7.7.2 Component Selection
This menu allows the user to select the desired component from the list