Ericsson RX8000 - ASI in Connector (Not RX8305); COMPONENT VIDEO Connector (RX8200 Only); IP DATA Connector (Not RX8305 or RX8330 C)

Installing the Equipment
2-10
EN/LZT 790 0005 R7A
2.3.12 IP DATA Connector (not RX8305 or RX8330C)
Units can provide two Ethernet data interfaces.
Table 2.11 IP DATA Connectors
Item Specification
Connector type RJ-45 (100BaseT)
Connector designation IP DATA 1
IP DATA 2
Pin-outs Pin 1 – Tx Out (+)
Pin 2 – Tx Out (-)
Pin 3 – Rx In (+)
Pin 4 – CMT
Pin 5 – CMT
Pin 6 – Rx In (-)
Pin 7 – CMT
Pin 8 – CMT
2.3.13 ASI IN Connector (Not RX8305)
Most units provide an ASI input socket for detection of the
transport stream lock on the ASI input.
Table 2.12 ASI IN Connector
Item Specification
Connector type BNC 75 Ω female socket
Connector designation ASI IN
Pin-outs Centre
Shield
Input
Ground/Chassis
2.3.14 COMPONENT VIDEO Connector (RX8200 only)
The equipment is equipped with a SVGA 15-pin D-type
connector for video output monitoring in the standard
configuration.
The SVGA connector shall be set to RGB/HV (SVGA) or
YPrPb under control of the User interface and remote
control interfaces.
ASI IN
COMPONENT VIDEO
IP DATA