Using the Equipment
C:\> ftp 172.17.110.9
2. Enter the username rx8000 and password rx8000:
Connected to 172.17.110.9.
220 RX8000 unit ready for user ...
User (172.17.110.9:(none)): rx8000
331 Password required for user rx8000.
Password:
230 User logged in.
ftp>
3. The current flash bank in use can be determined by sending the following
command:
ftp> quote site bankversion
200 running image from bank 0;
ftp>
4. Now send the command that will swap to the inactive flash bank. This command
will reboot the RX8000 device and make it boot to the other flash bank. The FTP
connection to the RX8000 will be lost.
ftp> quote site swap
3.22 Install Software with Upgrade Utility
3.22.1 Compatibility
The RX8000 Unit Upgrade Utility will only detect and upgrade RX8000 units that are
running release version 5.12.0 or later. For RX8000 units running an older release
version, these can be upgraded manually using the “Ethernet Upgrading” method
described in section 3.23 or as described in the Release Notes provided with a
release version.
3.22.2 Installation
RX8000 Unit Upgrade Utility is distributed in two forms:
• EXE file that installs the correct Java environment on a Windows PC.
• JAR file that can be launched on a PC running Linux or Windows.
3.22.2.1 EXE File Distribution
EXE file distribution is intended for Windows PC only.
To install the Upgrade Utility EXE file:
1. Double-click the RX8000 Unit Upgrade Utility EXE file to run the installer (e.g.
the file called RX8000UpgradeUtility-7.15.0.exe for version 7.15.0 distribution).
To Next Page
Loading...