Ericsson RX8000 - DVB-T;T2 Channel; DVB-T;T2 Scanning System; PLP FEC Frame Length; Tuning Frequency

Using the Equipment
EN/LZT 790 0005 R7A
3-131
• NON DVB T2
3.10.7.11.31 PLP FEC Frame Length
This menu shows the current PLP frame length within the T2 transmission.
STATUS |PL FEC FRAME LENGTH
3.2.1.2.8 |NORMAL
This can have the values:
• SHORT
• NORMAL
3.10.7.11.32 DVB-T/T2 Scanning system
This menu allows the user to configure the scanning system used by the tuner.
SETUP |SCANNING
3.2.2 |B/G
Use the  (Up)  (Down) keys to select the required value from the available
options.
• B/G
• D/K
3.10.7.11.33 DVB-T/T2 Channel
This menu allows the user to select the channel to be tuned to by the tuner.
STATUS |CHANNEL
3.2.1.1 |UHF G21
Use the  (Up)  (Down) keys to select the required value from the available
options. Channels are described in more detail above.
3.10.7.11.34 Tuning Frequency
This menu allows the user to input a tuning frequency into the DVB-T /T2 tuner.
STATUS |FREQUENCY
3.2.1.1 |230000
Use the  (Up)  (Down) keys to select the required value from the available
options. A value between 174000 and 23000 (kHz) should be used.