Using the Equipment
3.13.4.8 Front Panel Setup
3.13.4.8.1 Output
This menu allows access to and selection of the video and Transport Stream
outputs. To view this menu from the CA menu, press the (Down) key.
3.13.4.8.2 Output Selection
This menu provides sub-menus that enable the viewing and editing of output
functions for HD/SD-SDI/ASI BNC output connectors and IP Transport Stream
outputs. To view this menu from the above menu, press the (Forward) key.
OUTPUT |OUTPUT SELECTION
5.1 | >
3.13.4.8.3 Outputs One and Two
This menu enables the viewing and editing of output mode for HD/SD-SDI/ASI BNC
output connectors 1 and 2. To access this menu from the above menu, press the
(Forward) key.
OUTPUT |OUTPUT ONE : SD-SDI
5.1.1 |OUTPUT TWO : HD-HDI
Use the (Back) and (Forward) keys to toggle between OUTPUT ONE and
OUTPUT TWO. Use the (Up) and (Down) keys to toggle between the available
options.
This menu allows different configurations to be set:
• Auto – If the incoming video is 3G, the output BNC connector will be configured
as 3G-SDI. If the incoming video is HD, the output BNC connector will be
configured as HD-SDI. If the incoming video is SD, the output BNC connector
will be configured as (SD) SDI.
• HD-SDI – If the incoming video is HD the output BNC connector will be
configured as HD-SDI. If the incoming video is SD the output on the video out
BNC connector is invalid.
• SD-SDI – If the incoming video is HD the IRD will down-convert the native HD
video to SD and output on the video output BNC connector as (SD) SDI.
• 3G-SDI – Allows 1080P50/60 video content to be output on the Output BNC
connector as 3G-SDI. If the incoming video is SD or HD, the output on the video
out BNC connector is invalid.
To Next Page
Loading...