Alarm Identifiers
Name Identifier Description
MSF Invalid Operation 1062 Invalid configuration of the Multi-
Service Filter via SNMP such as the
case where the Single Filter Service
Slaved to Decode option is enabled.
MSF Overrate Protection Limit 1063 Packet buffer is nearly full and the
output rate has been raised to 200
Mbps. This only occurs when the
Buffer Overrate Protection mode is
enabled.
High TS Output Buffer 1064 Service Filter buffer is high and has
exceeded 85% full.
Bit rate Search ACTIVE 1065 The search minimum bit rate function
is active and will affect the output bit
rate on a live system.
C.2.9 Down Conversion Alarm Identifiers
Table C.9 Down Conversion Alarm Identifiers
Name Identifier Description
Down-converter FW Error 1070 Failure on the High Quality down-
conversion option card
Unsupported Video Format 1071 The output video resolution is not
supported by High Quality down-
conversion option card
C.2.10 Miscellaneous Input Alarm Identifiers
Table C.10 Miscellaneous Input Alarm Identifiers
Name Identifier Description
SNR 1080 Signal/Noise Ratio below threshold on
ATSC 8VSB input
C/N Margin 1081 Carriage/noise margin below threshold
on DVB-S2 Satellite input
G.703 Input Option Card Alarm 1082 General alarm from G.703 input
DVB-T2 Temperature 1083 Over temperature
DVB-T2 Software Error 1084 General error
DVB-T2 MER 1085 MER threshold
DVB-T2 BER 1086 BER threshold
DVB-T2 Power 1093 Diagnostics
To Next Page
Loading...
