Ericsson RX8000 - Mode; Represented Audio Format or Coding Standards; User PID; User STD

Using the Equipment
EN/LZT 790 0005 R7A
3-255
3.14.5.1.1.2 User PID / User STD
This menu enables the viewing and editing of User PID and User Coding Standard
(audio format) settings for the associated audio decoder.
AUDIO 1 |USER PID: 6553
4.7.1.2 |USER STD: MUS
Use the Edit key to modify the settings as described below.
Use the  (Back) and  (Forward) keys to navigate between USER PID and USER
STD. You will need to navigate past the four USER PID digits before the USER STD
is selected.
Use the  (Up) and  (Down) keys to increment or decrement the USER PID
value.
Use the  (Up) and  (Down) keys to toggle between the USER STD options.
Table 3.27 Represented Audio Format or Coding Standards
USER STD Represented Audio Format or Coding Standard
MUS MPEG-1 Audio Layer II or MPEG-2 Audio Layer II (sometimes called MUSICAM)
AC-3 Dolby Digital (AC-3)
E-AC-3 Dolby Digital Plus (DD+, E-AC-3 or Enhanced AC-3)
Linear Linear PCM
AAC (ADTS) Advancing Audio coding (AAC): Packaged in a streaming format called Audio Data
Transport Stream (ADTS)
AAC (LOAS) Advancing Audio coding (AAC): Packaged in a streaming format called Low
Overhead Audio Stream (LOAS)
HE-AAC High-Efficiency Advanced Audio Coding (HE-AAC)
HE-AAC (ADTS) High-Efficiency Advanced Audio Coding (HE-AAC): Packaged in a streaming format
called Audio Data Transport Stream (ADTS)
3.14.5.1.1.3 Mode
This menu enables the viewing and editing of default decoder mode or behavior for
the associated audio decoder.
AUDIO 1 |MODE: DECODE
4.7.1.3 |
After selecting the Edit key, use the  (Up) and  (Down) keys to toggle between
DECODE and PASS-THRU.