Using the Equipment
• User PID – Specifies the User PID that can be selected from the Remote Device
Control PID option.
• RDC Enable – Allows the remote device control functionality to be enabled or
disabled.
• Running – Indicates the current status of the Remote Device Control.
- Running – Remote Device Control data is being received, processed and
transmitted.
- Stopped – No Remote Device Control data is being processed.
• Packets Out – The number of Remote Device Control packets that have been
transmitted over the Ethernet interface.
• RDC Target IP Address – The IPv4 address to which the Remote Device
Control packets should be sent via the receiver's control interface. These can be
any valid IPv4 unicast, broadcast or multicast address. For unicast or broadcast
addresses, the packet will be sent over Control Port 1 or Control Port 2
according to the standard packet routing scheme determined by the Port's IP
address, Subnet Mask and the receiver's Gateway address. Multicast addresses
will be sent over the Control Port if the Multicast Enable option is enabled for
that particular port
• RDC Target UDP Port – The UDP port to which the Remote Device Control
packets should be sent.
• Control 1 / 2 – This displays the current status of the receiver's control ports as
configured on the Device Info > Network Settings webpage
- Control 1 > Multicast Enable – If checked, and a multicast IPv4 address is
entered in the RDC Target IP Address option, then the multicast packet will
be transmitted on Control Port 1.
- Control 2 > Multicast Enable – If checked, and a multicast IPv4 address is
entered in the RDC Target IP Address option, then the multicast packet will
be transmitted on Control Port 2.
Note: If Multicast Enable is selected for both Control 1 and Control 2, then two
packets will be transmitted, one on each interface.
3.18 Output Ports
The RX8000 can have many types of output depending upon the hardware options
fitted and the customization licenses applied to the unit. These outputs include:
• ASI output
• SDI output
• HD-SDI output
• 3G-SDI output
To Next Page
Loading...