Ericsson RX8000 - Front Panel Setup; Input Configure; Satellite

Using the Equipment
EN/LZT 790 0005 R7A
3-63
• TS Bit rate – Displays the bit rate of the Transport Stream input (in Mbps).
• Packet Length – Displays the packet length used in the Transport Stream.
• ASI Status – Displays the status of the ASI input option, this is not the same as
the motherboard lock status.
• Return to Primary – Checking this box specifies that when the Primary is
locked the unit will always return to the Primary after a timeout period, defined
below.
• Primary Lock Switch Period – Enables the user to define a period, in minutes,
before switching back to Primary, if Primary is not currently selected.
• Null Packet Override – Enables the user to control if redundancy switching
when a level of null packets is seen in enabled.
• ASI Null Packet Threshold – Enables the user to define a percentage
threshold of null packets seen by the ASI card before redundancy may happen.
• ASI Null Packet Occupancy – This provides the current level of null packets
seen by the ASI interface.
3.10.3.6 Front Panel Setup
3.10.3.6.1 Input Configure
This menu provides the ability to select both the primary and current Transport
Stream inputs
INPUT |SELECT INPUT ASI
3.1 |PRIMARY INPUT ASI
Use the  (Forward) and  (Back) keys to move between select input and primary
input then use the  (Up)  (Down) keys to select the required value from the
available options.
3.10.4 Satellite
3.10.4.1 Availability
 = Option B = Supplied with Base Model
RX8200 RX8252 RX8305 RX8310 RX8310B RX8315 RX8320 RX8330 RX8330C
  B B B B B B