Using the Equipment
using the video standard defined by the Default Output Standard. The
exception to this is if a test pattern is selected and the Test Pattern Standard is
set to anything other than AUTO. This setting will be overridden when video is
successfully decoded. When video decode fails, the unit will output video to the
last used standard for the fail mode screen.
- 480i 29.97Hz
- 576i 25Hz
- 1080i 30Hz
- 1080i 29.97Hz
- 1080i 25Hz
- 720p 60Hz
- 720p 59.94Hz
- 720p 50Hz
- 1080p 60Hz
- 180p 59.94Hz
- 1080p 50Hz
3.13.7.6 Front Panel Setup
3.13.7.6.1 User Configuration
This menu allows the user to setup the unit for non-SI based video decoding. This
allows the input of a user PID for video decoding and a user standard to attempt to
decode this PID.
VIDEO |USER PID : 000
4.5.2 |USER STD : MPEG 2
Once edit is selected the user can move between the USER PID and the USER
STD items using the Left and Right arrow keys. The user can enter a PID between
the values of 1…8191 using the (Up) and (Down) keys. Also the user can
toggle between MPEG 2 and MPEG-4 AVC for USER STD. These sections will not
be used unless for component selection 0 – USER is selected.
3.13.7.6.2 Default Output Standard
This menu allows the user to select an output standard for the unit to use until a
video input is detected for the first time after powering up.
VIDEO |DEFAULT OUTPUT STANDARD
4.5.5 |1080I 25HZ
To Next Page
Loading...