Using the Equipment
This field maps a physical Audio Output port to the output of one the Audio
Decoders available. The Audio Decoders available will vary depending on the
Channel Configuration mode selected.
The NO OUTPUT selection allows the user to stop any output coming from the
associated Audio Output port.
3.14.4.5.2 Audio Connectors > Status
The Status field is a read-only field that reports the Audio Decoder status. It reflects
the Audio Decoder Status reported in the main Decode page and confirms that the
audio is correctly being routed Audio Output port.
• RUNNING – The Audio Decoder is successfully decoding.
• STOPPED – The Audio Decoder is not active.
• ERROR – The Audio Decoder is experiencing errors during decode.
• UNLICENSED – The Audio Decoder cannot decode the audio format because
the unit does not have the appropriate license or the audio format is not
supported.
• UNAVAILABLE – The number of physical audio output connectors exceed the
number of Audio Decoders available.
• --- – Nothing is being routed to the audio output.
3.14.4.5.3 Audio Connectors > Clipping Level
This field specifies the Clipping Level (dB) to be applied to the associated analogue
output. The field accepts values between 0 dB and 20 dB.
3.14.4.6 Decode > Audio Output Routing > SDI Embedding
Figure 3.115 Decode > Audio Output Routing > SDI Embedding Window
To Next Page
Loading...