Fuji Xerox Document Centre C360 - Page 280

11 Setups
278
Setups
11
Output Color
Set the default value for [Output Color] in the [Basic Copying Tab] screen.
When [No Default] is selected, in the [Basic Copying Tab] screen, select the color mode
before starting to copy.
Single Color
Set the default value for [Output Color]>[More...]>[Single Color] in the [Basic Copying
Tab] screen. You can select from six preset colors and six custom colors.
For information about custom colors, refer to "Custom Colors" (P.285).
Dual Color - Source Color
Set the default value for [Source Color] that appears when [Output
Color]>[More...]>[Dual Color] is selected in the [Basic Copying Tab] screen.
After selecting [Color Selection], you can select from six colors.
Dual - Target Color (Target Area)
Set the default value for [Copy Color for Target Area] that appears when [Output
Color]>[More...]>[Dual Color] is selected in the [Basic Copying Tab] screen. You can
select from seven preset colors and six custom colors.
For information about custom colors, refer to "Custom Colors" (P.285).
Dual - Target Color (Non-target Area)
Set the default value for [Dual - Color (Non-target Area)] that appears when [Output
Color]>[More...]>[Dual Color] is selected in the [Basic Copying Tab] screen. You can
select from seven preset colors and six custom colors.
For information about custom colors, refer to "Custom Colors" (P.285).
Original Type
Set the default value for [Original Type] in the [Image Quality] screen.
Original Type - Auto (Non-Black)
Set the default value for [Original Type] in the [Image Quality] screen.
This is valid when [Auto] or [Full Color] is selected for [Output Color] in the [Basic
Copying Tab] screen.
Original Type - Auto (Black)
Set the default value for [Original Type] in the [Image Quality] screen.
This is valid when [Black] is selected for [Output Color] in the [Basic Copying Tab]
screen.
Lighten/Darken
Set the default value for [Lighten/Darken/Contrast] > [Lighten/Darken] in the [Image
Quality] screen.
Contrast
Set the default value for [Lighten/Darken/Contrast] > [Contrast] in the [Image Quality]
screen.
Sharpness
Set the default value for [Sharpness/Color Saturation] > [Sharpness] in the [Image
Quality] screen.