Fujitsu PRIMERGY TX2550 M5

5.3.7 Resetting the error status after replacing memory modules or
CPUs 120
5.3.7.1 Resetting the error status after replacing memory modules 120
5.3.7.2 Resetting the error status after replacing CPUs 121
5.3.8 Enabling the boot watchdog 123
5.3.9 Enabling replaced components in the BIOS 124
5.3.10 Verifying the memory mode 125
5.3.11 Verifying the system time settings 126
5.3.12 Viewing and clearing the System Event Log (SEL) 127
5.3.13 Updating the NIC configuration file in a Linux and VMware
environment 129
5.3.14 Resuming BitLocker functionality 130
5.3.15 Performing a RAID array rebuild 131
5.3.16 Looking for MAC/WWN/GUID and SAS addresses 132
5.3.16.1 Basic information 132
5.3.16.2 Looking for the MAC address of a LAN controller 132
5.3.16.3 Looking for the WWN address of a fibre channel controller 134
5.3.16.4 Looking for the GUID address of an infiniband or Omni-Path
controller 134
5.3.16.5 Looking for SAS addresses of SAS controllers for external
devices 135
5.3.17 Using the Chassis ID Prom Tool 136
5.3.18 Configuring LAN teaming 138
5.3.19 Switching off the ID indicator 139
5.3.20 Performing a fan test 140
5.3.21 Specifying the chassis model 141
6 Power supply unit (PSU)
143
6.1 Safety notes 143
6.2 Basic information 143
6.3 Redundant power supply 145
6.3.1 Installing a hot-plug PSU 145
6.3.2 Removing a hot-plug PSU 148
6.3.3 Replacing a hot-plug PSU 153
Content
TX2550 M5 Upgrade and Maintenance Manual