▶
Connect the Oculink cables to the PRAID EP5x0i as shown (1, 2).
Figure 229: Installing PRAID EP5x0i
▶
Install one PRAID EP5x0i in slot 8 (1).
▶
Install one PRAID EP5x0i in slot 9 (2).
▶
Connect the HDD LED cable to the connector "HDD LED1" on the system
board (3).
▶
Install one PRAID EP5x0i in slot 2.
▶
Connect the HDD LED cable to the connector "HDD LED2" on the system
board (4).
▶
If applicable, connect an FBU to the expansion card, see "Installing an
FBU" on page 380.
Expansion cards and backup units
354 Upgrade and Maintenance Manual TX2550 M5
To Next Page
Loading...
