Hioki 8847 - Page 6

Contents
iv
8.2 Displaying Waveforms During Recording (Roll Mode) ...124
8.3 Displaying New Waveforms Over Past Waveforms
(Overlay) .........................................................................125
8.4 Setting Channels to Use
(Extending the Recording Length) ..................................127
8.5 Converting Input Values (Scaling Function) ...................128
8.5.1 Scaling Setting Examples .................................................... 130
8.6 Variable Function (Setting the Waveform Display Freely) 134
8.7 Fine Adjustment of Input Values (Vernier Function) .......137
8.8 Inverting the Waveform (Invert Function) .......................138
8.9 Copying settings to other channels (calculation No.)
(Copy function) ...............................................................139
8.10 Making Detailed Settings for Input Modules ...................140
8.10.1 Making Settings for the Anti-Aliasing
Filter (A.A.F.) (8968 High Resolution Unit) .......................... 141
8.10.2 Probe Attenuation Selection ................................................ 141
8.10.3 Settings for the 8967 Temp Unit .......................................... 142
8.10.4 Settings for the 8969 Strain Unit .......................................... 144
8.10.5 Settings for the 8970 Freq Unit ............................................ 145
8.10.6 Settings for the 8971 Current Unit ....................................... 148
8.10.7 Settings for the 8972 DC/RMS Unit ..................................... 149
Chapter 9
Trigger Settings ___________________________151
9.1 Setting Workflow .............................................................152
9.2 Setting the Trigger Mode ................................................153
9.3 Triggering by Analog Signals ..........................................154
9.3.1 Analog Trigger Settings and Types ...................................... 154
9.4 Triggering by Logic Signals (Logic Trigger) ....................160
9.5 Trigger by Timer or Time Intervals (Timer Trigger) .........162
9.6 Applying an External Trigger (External Trigger) .............165
9.7 Triggering Manually (Manual Trigger) .............................165
9.8 Pre-Trigger Settings ........................................................166
9.8.1 Setting the Trigger Start Point (Pre-Trigger) ........................ 166
9.8.2 Setting Trigger Acceptance (Trigger Priority) ....................... 168
9.9 Setting Trigger Timing ....................................................169
9.10 Setting Combining Logic (AND/OR) for
Multiple Trigger Sources .................................................170
9.11 Using trigger settings to search measurement data .......171