HP Latex 3000 Series - Page 111

●
F
or both sides you can
dene the following properties:
◦
Number of copies: The number of total copies to print
◦
Number of columns: The number of copies to print horizontally, across the width of the
substrate
◦
Max: If this option is checked, the number of steps will be set to the maximum that will t into
the substrate width
●
For side A you can dene the following properties:
◦
Horizontal Margin: Gives the opportunity to dene a left margin that will be left blank
◦
Center: To center your jobs on the substrate so that there is an equal amount of white space
on both sides
NOTE: Centering the images is highly recommended to compensate for any possible
registration errors that may occur.
◦
Horiz
ontal Space: Gives the opportunity to dene the horizontal gap between copies
Pr
eview (Image/Layout/Preview both)
There are three dierent previews:
1. Main dialog of the job properties and preview how the printer will print each side.
ENWW Image composition 103