NOTE: The area dedicated to calibration, between the continuous registration line and the dotted line
(c), must be advanced at the same speed as the printed area, and at the same temperature, to ensure an
eective calibration.
4. When Side A has nished printing, unload side A. See Side A: Unload on page 74.
5. Check that the substrate-advance sensor is clean, and do not hesitate to clean it. See Clean the
substrate-advance sensor on page 231.
6. Load Side B. See Side B: Load and print on page 75.
NOTE: For accurate printing we recommend that Substrate Edge Detection is selected.
7. When Side B is loaded, perform the following steps. For more details of these procedures, refer to Side
B: Load and print on page 75:
106 Chapter 4 Create and manage print jobs ENWW
To Next Page
Loading...
