7. Slide the new roll onto the upper axle.
8. Insert the upper axle, placing the end cap on the side, and slide it all together until you hear a click.
9. Pass the leading edge of the roll over the upper rollers, and thread the cleaning material through the
rollers on the left.
10. There is a strip of polyester lm on the leading edge of the cleaning material. Insert it into the hole in the
takeup core, which takes hold of it.
11. Slide the takeup core onto the lower axle.
NOTE: If the cl
eaner roll has not been properly installed, you may see a message about clearing a
printhead cleaning roll jam. Pull the whole assembly out, wind a little of the roll forward, then slide it
back in again. The printer will check the roll again
132 Chapter 5 Handle the ink system ENWW
To Next Page
Loading...
