199
Step Command Remarks
4. Start transmission of OAM F5
Loopback cells or
retransmission check of OAM
F5 Loopback.
oam frequency
frequency [
up
up-count
down
down-count
retry-frequency
retry-frequency ]
Optional.
By default, OAM F5 Loopback cell
transmission is disabled.
However, if an OAM F5 Loopback
cell is received, it should be
responded.
By default, up-count is 3,
down-count is 5 and
retry-frequency is 1 second.
5. Set the PVC's service type
and rate-related parameters.
• Set the PVC's service type
to constant bit rate (CBR):
service cbr output-pcr
• Set the PVC's service type
to unspecified bit rate
(UBR), and set the
rate-related parameters:
service ubr output-pcr
• Set the PVC's service type
to nrt-VBR, and set the
rate-related parameters:
service vbr-nrt output-pcr
output-scr output-mbs
• Set the PVC's service type
to rt-VBR, and set the
rate-related parameters:
service vbr-rt output-pcr
output-scr output-mbs
Optional.
By default, the service type of a
PVC is UBR.
You can use these four
commands to set the service type
and the parameters concerning
transmission rate. A newly
configured service type
overwrites the existing one.
6. Configure the service type
(use different commands
according to service types).
• Configure IPoA and enable
inverse address resolution
(InARP) for the PVC:
map ip inarp [ minutes ]
[ broadcast ]
• Establish PPPoA mapping
for the PVC:
map ppp virtual-template
vt-number
• Establish IPoEoA or
PPPoEoA mapping for the
PVC:
map bridge
virtual-ethernet
interface-number
Optional.
By default, mapping is not
configured. When a mapping is
configured, pseudo-broadcast is
not supported by default.
Before configuring InARP, make
sure the aal5snap encapsulation
is used. Though InARP is also
supported when using aal5mux or
aal5nlpid encapsulation, the
system will prompt a message
indicating a failure when this ATM
is configured and used on PVC.
7. Return to system view
quit
N/A
To Next Page
Loading...
Need help?
General
