HPE FlexNetwork MSR Series Comware 5 Layer 2 - Wan Access Configuration Guide

252
3. If the PU type is correct, use the display dlsw circuit verbose command to check whether the
virtual circuit can enter the CIRCUIT_EST state. If not, the MAC address of the SDLC peer is
not correctly configured. Use the sdlc mac-map remote command to modify the configuration
parameters.
4. If the circuit can reach the CIRCUIT_EST state but cannot reach the CONNECTED state, the
configuration of the SDLC on the router does not match that of the SNA devices. Check the
configuration of the SDLC devices on both sides and the router. For example, check whether
the XID (PU2.1) of the SNA device is correctly configured, and whether the XID (PU2.0) of the
router is correctly configured. If all these configurations are correct, check whether the SDLC
line on the primary SDLC device side (such as the AS/400 or S390) is activated. Sometimes the
SDLC line needs to be activated manually.

HPE FlexNetwork MSR Series Specifications

General

Brand	HPE
Model	FlexNetwork MSR Series
Category	Network Router
Language	English