HPE FlexNetwork MSR Series Comware 5 Layer 2 - Wan Access Configuration Guide

323
Task Remarks
Enabling the sending of broadcast packets through
X.25
Optional.
Restricting the use of address mapping
Optional.
Setting the maximum SVC idle interval
For the sake of cost saving, specify an SVC idle time on the expiration of which the SVC will be
disconnected. Enabling this feature will not affect the data transmission, because the SVC can be set
up again if new packets are waiting for transmission.
To set the maximum SVC idle interval:
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enter interface view.
interface
interface-type
interface-number
N/A
3. Set the maximum idle
interval for all the SVCs on
the interface.
x25 timer idle
minutes
Optional.
0 minutes by default, where no
SVC cleared automatically.
4. Set the maximum idle
interval for an SVC
associated with an address
mapping.
x25 map
protocol-type
protocol-address
x121-address
x.121-address
idle-timer
minutes
Optional.
No mapping is created by default.
If created, the value defaults to 0
minutes, where no SVC cleared
automatically.
Setting the maximum number of SVCs that can be associated with one address mapping
You can specify the maximum number of SVCs allowed to set up for one address mapping. By
default, an X.25 address mapping can only be associated with one virtual circuit. In case of busy
traffic and slow line speed, increase this number appropriately to reduce data loss. Up to eight SVCs
can be associated with an X.25 address mapping.
To set the maximum number of SVCs that can be associated to one address mapping:
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enter interface view.
interface
interface-type
interface-number
N/A
3. Set the maximum number of
SVCs that can be associated
to the same address
mapping.
• Set the maximum number of
SVCs that can be associated
for all the address mappings
on the X.25 interface:
x25 vc-per-map count
• Set the maximum number of
SVCs that can be associated
to an address mapping:
x25 map protocol-type
protocol-address
x121-address
x.121-address vc-per-map
count
Optional.
The count defaults to 1.

HPE FlexNetwork MSR Series Specifications

General

Category	Network Router
WAN Ports	Varies by model
LAN Ports	Varies by model
Switching Capacity	Varies by model
IPv6 Support	Yes
Product Series	MSR Series
Routing Protocols	BGP, OSPF, RIP, IS-IS, Static Routing
WAN Interfaces	Ethernet, Serial, T1/E1
LAN Interfaces	Ethernet, Fast Ethernet, Gigabit Ethernet
Power Supply	AC or DC (varies by model)
Management	CLI, Web GUI, SNMP
VPN Support	IPsec, GRE, L2TP, DMVPN
QoS Support	Yes
Ports	Varies by model
Firewall	Stateful packet inspection, DoS/DDoS protection, Application layer filtering