HPE FlexNetwork MSR Series Comware 5 Layer 2 - Wan Access Configuration Guide

39
Link layer protocol is PPP
LCP opened, MP opened, IPCP opened, OSICP opened
Physical is MP, baudrate: 64000 bps
Output queue : (Urgent queuing : Size/Length/Discards) 0/100/0
Output queue : (Protocol queuing : Size/Length/Discards) 0/500/0
Output queue : (FIFO queuing : Size/Length/Discards) 0/75/0
Last 300 seconds input: 0 bytes/sec 0 packets/sec
Last 300 seconds output: 0 bytes/sec 0 packets/sec
520 packets input, 44132 bytes, 0 drops
527 packets output, 44566 bytes, 4 drops
The output on Router B is similar.
5. Ping the IP address 8.1.1.1 on Router B:
[RouterB] ping 8.1.1.1
PING 8.1.1.1: 56 data bytes, press CTRL_C to break
Reply from 8.1.1.1: bytes=56 Sequence=1 ttl=255 time=29 ms
Reply from 8.1.1.1: bytes=56 Sequence=2 ttl=255 time=31 ms
Reply from 8.1.1.1: bytes=56 Sequence=3 ttl=255 time=29 ms
Reply from 8.1.1.1: bytes=56 Sequence=4 ttl=255 time=31 ms
Reply from 8.1.1.1: bytes=56 Sequence=5 ttl=255 time=30 ms
--- 8.1.1.1 ping statistics ---
5 packet(s) transmitted
5 packet(s) received
0.00% packet loss
round-trip min/avg/max = 29/30/31 ms
Because PPP authentication is configured on the physical interface, the bundle field in the
output from the display ppp mp command is the peer username. If authentication is disabled,
the bundle field should be the peer descriptor.
In addition, you can check the state of MP virtual channels by checking the state of virtual
access interfaces by using the display virtual-access command.
(Method 2) Associate the remote username with a VT interface.
6. Configure Router A:
# Configure the username and password of Router B.
<RouterA> system-view
[RouterA] local-user rtb
[RouterA-luser-rtb] password simple rtb
[RouterA-luser-rtb] service-type ppp
[RouterA-luser-rtb] quit
# Specify a VT interface to user RTB.
[RouterA] ppp mp user rtb bind virtual-template 1
# Create the VT interface and configure its IP address.
[RouterA] interface virtual-template 1
[RouterA-Virtual-Template1] ip address 8.1.1.1 24
[RouterA-Virtual-Template1] ppp mp binding authentication
[RouterA-Virtual-Template1] quit
# Configure Serial 2/1.
[RouterA] interface serial 2/1
[RouterA-Serial2/1] link-protocol ppp

HPE FlexNetwork MSR Series Specifications

General

Brand	HPE
Model	FlexNetwork MSR Series
Category	Network Router
Language	English