HPE FlexNetwork MSR Series

53
2. Configure Router B as the PPPoE client:
<RouterB> system-view
[RouterB] dialer-rule 1 ip permit
[RouterB] interface dialer 1
[RouterB-Dialer1] dialer user user2
[RouterB-Dialer1] dialer-group 1
[RouterB-Dialer1] dialer bundle 1
[RouterB-Dialer1] ip address ppp-negotiate
[RouterB-Dialer1] ppp pap local-user user2 password simple hello
[RouterB-Dialer1] quit
# Configure the PPPoE session.
[RouterB] interface ethernet 1/1
[RouterB-Ethernet1/1] pppoe-client dial-bundle-number 1
Configuring CHAP authentication
1. Configure Router A as the PPPoE server:
# Add a PPPoE user.
<RouterA> system-view
[RouterA] local-user user2
[RouterA-luser-user2] password simple hello
[RouterA-luser-user2] service-type ppp
[RouterA-luser-user2] quit
# Configure virtual template 1.
[RouterA] interface virtual-template 1
[RouterA-Virtual-Template1] ppp authentication-mode chap
[RouterA-Virtual-Template1] ppp chap user user1
[RouterA-Virtual-Template1] ip address 1.1.1.1 255.0.0.0
[RouterA-Virtual-Template1] remote address 1.1.1.2
[RouterA-Virtual-Template1] quit
# Configure the PPPoE server.
[RouterA] interface ethernet 1/1
[RouterA-Ethernet1/1] pppoe-server bind virtual-template 1
2. Configure Router B as the PPPoE client:
<RouterB> system-view
[RouterB] dialer-rule 1 ip permit
[RouterB] interface dialer 1
[RouterB-Dialer1] dialer user user2
[RouterB-Dialer1] dialer-group 1
[RouterB-Dialer1] dialer bundle 1
[RouterB-Dialer1] ip address ppp-negotiate
[RouterB-Dialer1] ppp chap user user2
[RouterB-Dialer1] quit
[RouterB] local-user user1
[RouterB-luser-user1] password simple hello
[RouterB-luser-user1] quit
# Configure the PPPoE session.
[RouterB] interface ethernet 1/1
[RouterB-Ethernet1/1] pppoe-client dial-bundle-number 1