HPE FlexNetwork MSR Series User Manual

318
Figure 332 Adding a user account
Configuring the RADIUS server on IMC
This example assumes that the RADIUS server runs on IMC PLAT 3.20-R2602 and IMC UAM
3.60-E6102.
1. Add the router to IMC as an access device:
a. Log in to IMC:
b. Click the Service tab.
c. Select Access Service > Service Configuration from the navigation tree.
d. Click Add.
e. Enter expert as the shared key for authentication and accounting.
f. Enter 1812 and 1813 as the ports for authentication and accounting, respectively.
g. Select Device Management Service as the service type.
h. Select HP as the access device type.
i. Select the access device from the device list, or manually add the device with the IP
address of 10.1.1.2.
The IP address of the access device must be the same as the source IP address of the
RADIUS packets sent from the router. By default, the source IP address of a RADIUS
packet is the IP address of the sending interface.
j. Click OK.

HPE FlexNetwork MSR Series Specifications

General

Brand	HPE
Model	FlexNetwork MSR Series
Category	Network Router
Language	English