Keithley 2450 User Manual

Section
5: Introduction to SCPI commands Model 2450 Interactive SourceMeter® Instrument
Reference Manual
5-6 2450-901-01 Rev. B/September 2013
Command usage
The Usage section of the remote command listing shows how to properly structure the command.
Each line in the Usage section is a separate variation of the command usage; all possible command
usage options are shown here.
Figure 123: SCPI command description usage identification
1 Structure of command usage: Shows how the parts of the command should be organized.
2 User-supplied parameters: Indicated by angle brackets (< >).
Some commands have optional parameters. Optional parameters are presented on separate lines in
the Usage section, presented in the required order with each valid permutation of optional
parameters. For example:
:SYSTem:COMMunication:LAN:CONFigure AUTO
:SYSTem:COMMunication:LAN:CONFigure MANual, IPaddress
:SYSTem:COMMunication:LAN:CONFigure MANual, IPaddress, NETmask
:SYSTem:COMMunication:LAN:CONFigure MANual, IPaddress, NETmask, GATeway
:SYSTem:COMMunication:LAN:CONFigure?
3 Parameter value options: Descriptions of the options that are available for the parameter.
Command details
This section lists additional information you need to know to successfully use the command.
Figure 124: Details section of command listing
Example section
The Example section of the command description shows some simple examples of how the
command can be used.

Keithley 2450 Specifications

General

Model	2450
Category	SourceMeter
Voltage Source Range	±200 V
Current Source Range	±1 A
DC Voltage	200 V
DC Current	1 A
Power Output	20 W
Resolution	6.5 digits
Display	5-inch capacitive touchscreen
Operating Temperature	0°C to 50°C
Connectivity	USB, LAN, GPIB
Dimensions	213 mm × 88 mm × 370 mm