Keithley 2450

Section
6: SCPI command reference Model 2450 Interactive SourceMeter® Instrument
Reference Manual
6-34 2450-901-01 Rev. B/September 2013
:OUTPut[1][:STATe]
This command enables or disables the source output.
Type Affected by Where saved Default value
Command and query
Recall settings
Instrument reset
Power cycle
Source configuration list
Save settings
Source configuration list
0 (OFF)
Usage
:OUTPut[1][:STATe] <b>
:OUTPut[1][:STATe]?
<b>
Turn source off: 0 or OFF
Turn source on: 1 or ON
Details
When the output is switched on, the instrument sources either voltage or current, as set by
[:SOURce[1]]:FUNCtion[:MODE].
Example
:OUTP ON
Switch the source output of the instrument to
on.
Also see
:SOURce[1]:FUNCtion[:MODE] (on page 6-72)