Keithley 2450

Section
6: SCPI command reference Model 2450 Interactive SourceMeter® Instrument
Reference Manual
6-14 2450-901-01 Rev. B/September 2013
:CALCulate2:<function>:LIMit<Y>:CLEar[:IMMediate]
This command clears the results of the limit test.
Type Affected by Where saved Default value
Command only Not applicable Not applicable Not applicable
Usage
:CALCulate2:<function>:LIMit<Y>:CLEar[:IMMediate]
<function>
The function to which this setting applies:
• Current: CURRent[:DC]
• Resistance: RESistance
• Voltage:
VOLTage[:DC]
<y>
The limit that the setting applies to, 1 or 2
Details
Use this command to clear the test results of limit Y when the limit auto clear command is disabled. Both the high
and low test results are cleared.
To avoid the need to manually clear the test results for a limit, enable the auto clear command.
If you send this command without the <function> parameter, it will set the limit for all functions.
Example
calc2:curr:lim1:clear
Clear the results for limit test 1.
Also see
:CALCulate2:<function>:LIMit<Y>:LOWer[:DATA] (on page 6-16)
:CALCulate2:<function>:LIMit<Y>:UPPer[:DATA] (on page 6-18)