To Next Page

To Previous Page

Section

6: SCPI command reference Model 2450 Interactive SourceMeter® Instrument

Reference Manual

6-156 2450-901-01 Rev. B/September 2013

:TRIGger:LAN<n>:IN:OVERrun?

This command indicates the overrun status of the event detector.

Type Affected by Where saved Default value

Query only TRIGger:LAN<n>:IN:CLEar Not applicable Not applicable

Usage

:TRIGger:LAN<n>:IN:OVERrun?

<n>

The LAN event number (1 to 8)

Details

This attribute indicates whether an event has been ignored because the event detector was already in the

detected state when the event occurred.

This is an indication of the state of the event detector built into the synchronization line itself. It does not indicate

if an overrun occurred in any other part of the trigger model, or in any other construct that is monitoring the event.

It also is not an indication of an output trigger overrun.

The trigger overrun state for the specified LAN packet is returned as 1 (true) or 0 (false).

Example

TRIG:LAN5:IN:OVER?

Checks the overrun status of a trigger on LAN5

and outputs the value, such as:

Also see

:TRIGger:LAN<n>:IN:CLEar (on page 6-154)

Keithley 2450 User Manual

Other manuals for Keithley 2450