Keithley 2450 User Manual

Section
8: TSP command reference Model 2450 Interactive SourceMeter® Instrument
Reference Manual
8-24 2450-901-01 Rev. B/September 2013
Example
reset()
testData = buffer.make(100)
trigger.model.load("SimpleLoop", 3, 0, testData)
trigger.model.initiate()
waitcomplete()
print(testData.n)
print(defbuffer1.n)
print(defbuffer2.n)
Create a reading buffer named
testData, configure the instrument to
make three measurements, and store the
readings in the buffer.
Print the number of readings in
testData:
Output:
3
Print the number of readings in
defbuffer1:
Example output:
66
Print the number of readings in
defbuffer2:
Example output:
0
Also see
buffer.delete() (on page 8-9)
buffer.make() (on page 8-11)
bufferVar.clear() (on page 8-17)
print() (on page 8-77)
printbuffer() (on page 8-78)
Reading buffers (on page 3-10)
Remote buffer operation (on page 3-27)
bufferVar.readings
This attribute contains the readings stored in a specified reading buffer.
Type TSP-Link accessible Affected by Where saved Default value
Attribute (R)
Yes
Restore configuration
Instrument reset
Power cycle
Not applicable
Not applicable
Usage
readings = bufferVar.readings[N]
readings
The readings in the specified reading buffer
bufferVar
The name of the reading buffer, which may be a default buffer (defbuffer1 or
defbuffer2
) or a user-defined buffer
N
The reading number N; can be any value between 1 and the number of readings in
the buffer; use the bufferVar.n command to determine the number of readings
in the buffer
Example 1
reset()
tD = buffer.make(50)
trigger.model.load("SimpleLoop", 3, 0, tD)
trigger.model.initiate()
waitcomplete()
print(tD.readings[1])
Create a reading buffer named tD, configure the
instrument to make three measurements, and
store the readings in the buffer.
Print the first reading in tD.
Output:
-9.6420389034124e-12

Keithley 2450 Specifications

General

Brand	Keithley
Model	2450
Category	Test Equipment
Language	English