Keithley 2450

Section
6: SCPI command reference Model 2450 Interactive SourceMeter® Instrument
Reference Manual
6-38 2450-901-01 Rev. B/September 2013
[:SENSe[1]]:CONFiguration:LIST:DELete
This command deletes a measure configuration list.
Type Affected by Where saved Default value
Command Not applicable Not applicable Not applicable
Usage
[:SENSe[1]]:CONFiguration:LIST:DELete <name>
[:SENSe[1]]:CONFiguration:LIST:DELete <name>, <point>
<name>
A string that represents the name of a measure configuration list
<point>
A specific configuration point in the configuration list
Details
Deletes a configuration list. If the point parameter is not specified, the entire configuration list is deleted. If the
point parameter is specified, only the specified configuration point in the list is deleted.
Examples
:SENSe:CONF:LIST:DELete "myMeasList"
Deletes a configuration list named
myMeasList
.
:SENSe:CONF:LIST:DELete "myMeasList", 2
Deletes configuration point 2, in a
configuration list named
myMeasList.
Also see
Configuration lists (on page 3-33)
[:SENSe[1]]:CONFiguration:LIST:CREate (on page 6-37)