Keithley 2450 User Manual

Section
8: TSP command reference Model 2450 Interactive SourceMeter® Instrument
Reference Manual
8-234 2450-901-01 Rev. B/September 2013
Example
lineState = tsplink.line[3].state
print(lineState)
Assume line 3 is set high, and then the state is read.
Output:
tsplink.STATE_HIGH
Also see
tsplink.line[N].mode (on page 8-232)
tsplink.master
This attribute reads the node number assigned to the master node.
Type TSP-Link accessible Affected by Where saved Default value
Attribute (R)
Yes
Not applicable
Not applicable
Not applicable
Usage
masterNodeNumber = tsplink.master
masterNodeNumber
The node number of the master node (1 to 64)
Details
This attribute returns the node number of the master in a set of instruments connected using TSP-Link.
Example
LinkMaster = tsplink.master
Store the TSP-Link master
node number in a variable
called LinkMaster.
Also see
tsplink.initialize() (on page 8-231)
tsplink.node
This attribute defines the node number.
Type TSP-Link accessible Affected by Where saved Default value
Attribute (RW)
Yes
Not applicable
Nonvolatile
memory
2
Usage
nodeNumber = tsplink.node
tsplink.node = nodeNumber
nodeNumber
The node number of the instrument or enclosure (1 to 64)
Details
This attribute sets the TSP-Link node number and saves the value in nonvolatile memory.
Changes to the node number do not take effect until tsplink.reset() from an earlier TSP-Link instrument or
tsplink.initialize() is executed on any node in the system.
Each node connected to the TSP-Link system must be assigned a different node number.

Keithley 2450 Specifications

General

Brand	Keithley
Model	2450
Category	Test Equipment
Language	English