Keithley 2450

Section
8: TSP command reference Model 2450 Interactive SourceMeter® Instrument
Reference Manual
8-20 2450-901-01 Rev. B/September 2013
Example
reset()
testData = buffer.make(50)
print(testData.fillmode)
testData.fillmode = buffer.FILL_CONTINUOUS
print(testData.fillmode)
defbuffer2.fillmode = buffer.FILL_ONCE
print(defbuffer2.fillmode)
Create a reading buffer named testData,
configure the instrument to make three
measurements, and store the readings in the
buffer.
Print the fillmode setting for the testData
buffer.
Output:
0
Set fillmode to continuous.
Print the fillmode setting for the testData
buffer.
Output:
1
Set defbuffer2 fillmode to fill once and stop.
Print the fillmode setting for the defbuffer2
buffer.
Output:
0
Also see
buffer.delete() (on page 8-9)
buffer.make() (on page 8-11)
bufferVar.clear() (on page 8-17)
print() (on page 8-77)
printbuffer() (on page 8-78)
Reading buffers (on page 3-10)
Remote buffer operation (on page 3-27)
bufferVar.formattedreadings
This attribute contains the stored readings formatted as they appear on the front-panel display.
Type TSP-Link accessible Affected by Where saved Default value
Attribute (R)
Yes
Restore configuration
Instrument reset
Power cycle
Not applicable
Not applicable
Usage
readings = bufferVar.formattedreadings[N]
readings
Buffer reading formatted as it appears on the front-panel display for element
N
bufferVar
The name of the reading buffer, which may be a default buffer (defbuffer1 or
defbuffer2
) or a user-defined buffer
N
The reading number N; can be any value between 1 and the number of readings in
the buffer; use the bufferVar.n command to determine the number of readings
in the buffer
Details
This read-only attribute is an array (a Lua table) of strings that indicate the formatted reading as viewed on the
front-panel display.